ABS Sensor
ABS Sensor
Hi,
so my front right abs sensor has went bad... i am trying to order a sensor from rock auto but wondering why there is two different types available?
OEM: 89542 30160
Aftmrkt: ABS806 or ALS696
1) under speed sensor category you see ones without wires:
2) when i type abs sensor i get these full sensor with wires
i was assuming abs sensors on SC come as one piece right? the wires dont seperate from the sensor? unless sensors in 1) are for some other area on the car
Thanks guys
so my front right abs sensor has went bad... i am trying to order a sensor from rock auto but wondering why there is two different types available?
OEM: 89542 30160
Aftmrkt: ABS806 or ALS696
1) under speed sensor category you see ones without wires:
2) when i type abs sensor i get these full sensor with wires
i was assuming abs sensors on SC come as one piece right? the wires dont seperate from the sensor? unless sensors in 1) are for some other area on the car
Thanks guys
Lexus Test Driver
Joined: Dec 2014
Posts: 8,213
Likes: 949
From: Fl
What are the symtoms of it going bad and did you recently have any front end work performed?
I ask because I had an issue right after I replaced a bunch of parts on my front end.
I did a battery disconnect/reconnect and everything was fine again
I ask because I had an issue right after I replaced a bunch of parts on my front end.
I did a battery disconnect/reconnect and everything was fine again
Lexus Test Driver
Joined: Dec 2014
Posts: 8,213
Likes: 949
From: Fl
When it happened to me, I
removed the one screw holding the sensor,
pulled it out,
wiped the grease off the end,
reinstalled,
Disconnected the battery terminal for five minutes
Reconnected,
Reset the codes using my code reader and reset the lights by shorting OBDII pins 4&14.
No more issues
Did you address this problem, in another thread several weeks ago, or did this just happen?
removed the one screw holding the sensor,
pulled it out,
wiped the grease off the end,
reinstalled,
Disconnected the battery terminal for five minutes
Reconnected,
Reset the codes using my code reader and reset the lights by shorting OBDII pins 4&14.
No more issues
Did you address this problem, in another thread several weeks ago, or did this just happen?
When it happened to me, I
removed the one screw holding the sensor,
pulled it out,
wiped the grease off the end,
reinstalled,
Disconnected the battery terminal for five minutes
Reconnected,
Reset the codes using my code reader and reset the lights by shorting OBDII pins 4&14.
No more issues
Did you address this problem, in another thread several weeks ago, or did this just happen?
removed the one screw holding the sensor,
pulled it out,
wiped the grease off the end,
reinstalled,
Disconnected the battery terminal for five minutes
Reconnected,
Reset the codes using my code reader and reset the lights by shorting OBDII pins 4&14.
No more issues
Did you address this problem, in another thread several weeks ago, or did this just happen?
but ill try disconnecting terminal for a few minutes. thank you!
Thread
Thread Starter
Forum
Replies
Last Post
