Speaker replacement '13 GS
08-10-23, 01:28 PM
#16
The GS’s ML stinks imo. I’ve replaced every front stage speaker so far and added a sub. Only thing left is to install my DSP and send more power and tune the speakers. Went with HAT L2SE for fronts, L3SE for center channel, HAT 6x9’s for the doors. Or Audiofrog 6.5’s. Will have to play with them and see which I like more.
the 2IS I previously had without ML had a much better 3way front stage system than this ML gs unfortunately. I think that is due to the tweeterless design.
08-10-23, 02:26 PM
#17
you can just unplug it at the sub. I did the same as I added an aftermarket sub and amp.
The GS’s ML stinks imo. I’ve replaced every front stage speaker so far and added a sub. Only thing left is to install my DSP and send more power and tune the speakers. Went with HAT L2SE for fronts, L3SE for center channel, HAT 6x9’s for the doors. Or Audiofrog 6.5’s. Will have to play with them and see which I like more.
the 2IS I previously had without ML had a much better 3way front stage system than this ML gs unfortunately. I think that is due to the tweeterless design.
The GS’s ML stinks imo. I’ve replaced every front stage speaker so far and added a sub. Only thing left is to install my DSP and send more power and tune the speakers. Went with HAT L2SE for fronts, L3SE for center channel, HAT 6x9’s for the doors. Or Audiofrog 6.5’s. Will have to play with them and see which I like more.
the 2IS I previously had without ML had a much better 3way front stage system than this ML gs unfortunately. I think that is due to the tweeterless design.
Last edited by jgscott; 08-10-23 at 02:30 PM.
08-10-23, 03:04 PM
#18
just need to find 2-3 days to rip apart the interior again and run speaker wires and deaden the rear deck some more as I’m still getting a little rattle with certain frequencies.
Thread
Thread Starter
Forum
Replies
Last Post