can you guys tell me what the inlet size is? Maybe yall can link me? i rather see a selection. Every shop around me has limited tips. I just got my body kit installed and my rear bumper looks incomplete. i bought a pair of tips last week and i had to take it back to the shop, i thought they were all the same size.

 

get an ID tip of 2.5"....its just a bit larger than the OD of the tail pipe....then get it tac welded.

 

drew sells the borla for a good price if u like those PM him!

 

yes drewgs4!

 

Go with the Borlas from DrewGS4!!

 

Fourthded. Very happy with my Borlas from Drew.

 

Fifthed for Drewgs4..Then maybe we will let you in the SLSM club..

 

Hmmm . . will those borla's match up with my veilside executive rears? i just want that aggressive look and i can just take a break from my exterior mods list. If so . . PLEASE LINK MEEEEE!!!!

 

my car:



all the guys up top said it before, and ill say it again, DREWGS4!! haha, this guy should still have these, he's reasonable on price, ships hella fast and the borlas are a nice clean not too overstated look. plus, since they clamp on, you can adjust where/how far out or in you want these things to sit, which will compliment your bumper exactly how you want them too....and if you're part of the SLSMC these can possibly help that issue without having serious exhaust work done to rebend or having to change out the rubber hangers since you can shift these arount a little till they sit right....