Shift Lever re-wire!

 

^^^
You finally got around to it !! I remember you saying that it bugged you. Big props for actually taking the time to figure it out. Personally I got use to it. Would mess me up bad now if I switched.
Btw love that trd **** !!
Headers back yet from coating??

 

Yeah, I finally did. I actually was installing a bigger/android screen so I had to take that center console out and decided to look for the connector Too bad the screen ends up messing with the beatsonic camera interface so I had to put the factory screen back on.

Only 2 weeks into the headers being coated. They estimate 3
weeks and could creep into a 4th week they said, so we’ll see! I sent them to Swain Technology coatings btw, went for the white lightning coating.

also, replaced some more fasteners with lighter ones!

 

a little something from Japan!

 

Wooooo!! You always got something tasty going on.
What kind of filter? Can’t see good

 

haha!
the filter is a small cone style stainless, so small there’s so much room left in the box I’ll give it a try but I might get a bigger K&N.

 

Stainless?
Can’t see that filtering too well. Prolly good for hp but poor for long term internal wear..

 

I agree, I‘m looking for a K&N replacement that has a 4.5” flange diameter and a slight angle.

 

Made a couple heatshields!

 

Thank you!

 

Still waiting for the headers so I cleaned and clear sprayed some parts while they are off the car.





And got around to replacing more fasteners with titanium.















Titanium/ss nuts and bolts, header collectors to midpipes.

 

Got a bigger K&N filter, titanium top of course
Perfect fit!

 

Where the heck did you get a Ti topped filter???

 

Was searching on the dimensions that I needed and it popped up as one of the results

 

Headers back from swain tech, time to get back to work!