Lexus IS: How to Install ISF Rear Bumper
An ISF rear bumper adds a great, sporty look to the Lexus IS. Here is how to install it yourself in just a couple of hours.
This article applies to the Lexus IS 250, IS 350 (2005-2013).
An ISF rear bumper cover is an easy upgrade to install in a few hours. It enhances the modified look of the Lexus IS. Learn how to install it yourself below.
Materials Needed
- Metric sockets
- Flathead and Phillips screwdrivers
- Metric wrenches
- Specialized clip removal tools (recommended)
Step 1 - Remove the existing rear bumper
Working from underneath the rear of the car, remove the clips and bolts that hold the bumper on. You will need to remove some bolts from the bottom of the bumper, and the rest you can reach from the inside of the trunk.
Figure 1. Bolt locations underneath bumper. 
Figure 2. Bolt locations inside trunk. 
Figure 3. Removing bolts from trunk. 
Figure 4. Bumper removed.
Pro Tip
Use a fishing tackle box or other box with compartments to put the fasteners in. Put them in the box in an orderly fashion so reassembly is in reverse order. That way you know where they go.
Step 2 - Install the new bumper
Installation is the opposite of removal. Be sure to test fit the bumper for proper alignment with the mounting tabs and exhaust.
Figure 5. Test fit the new bumper before painting. 
Figure 6. New ISF bumper installed.
Pro Tip
This would be a good time to upgrade your reflectors, exhaust tips, and tow hook covers.
Related Discussion
- My IS-F Rear End Conversion: Full Photo Guide - ClubLexus.com
