Miata

Hello, I was browsing enjuku racing for some Miata bits and bobs and decided to check out the Lexus section to see if they offered anything for the S160 GS, To my surprise they had a lot of control arms and braces. These arms were from “Serial 999” and look pretty decent, I was wondering if anybody has had any experience with their control arms and bushings for the GS? Thanks

CAKETOWN

iTrader: (7)

I have the front upper control arms and toe arms...i find the fuca to be pretty noisey and they should've had a dust boot to keep dirty of the the area. Also the powder coating wasnt very durable.

Miata

firelizard

iTrader: (1)

Good for drift/show, not great for daily. Not so much because of quality, but they're not really meant for it- very rigid bushings and spherical joints. Great for people looking to do a more extreme stance than other parts allow, or for people using the S160 platform to drift. I'm a fan, since they started out making out what people needed and have kept up the good work in that vein.

Meowmr2

iTrader: (1)

Spherical joints/ heim joints will always make a lot more noise, there is not cushion. I run some of their products, I will say it is some good stuff. The north american Distributor is http://www.tf-works.com/gs300-gs350-gs400/

status....

Just installed my rear lower arms and had my car aligned the other week. Quality, fit and finish are great,