So I ordered the bezel, and finally found the time to do the shift mod...works pretty well, just had to break the black plastic spring support and fit a washer under the tensioner.

 

i like it very good job

 

what right up did you use? or did you just wing it? i've been thinking about doing it as well..

 

lol nice work bro...

 

Same here bro...

Did you have to cut into the metal shaft to attach the shifter ?
I thought they didn't make these shifters anymore.

 

dont bump it into park

 

Was gonna use a write up but just ended up winging it. It's really not that bad.
Um, I got the shifter off an auction site, just put in carbon fiber shift **** automatic. I ended up just breaking the black tensioner and replacing it with a washer...then took an angle grinder (over kill) haha and trimmed the bottom of the actual **** about an inch and a half rather than cut the metal bracket on the car.

 

I did the same thing......except I added a couple steps by putting a w58 under it....lol

 

what did you two do with your power/od buttons?

 

yeah i was gonna ask the same thing.... what did you do with the power button? lol looks good btw

 

I relocated the O/D button to the center cup holder.
I'll be putting it in the center armrest eventually.
I don't really use it much.

 

Nice mod man, you should've gotten the bezel w/ the Lexus logo on it. I love that little logo on the bezel.

 

Its either Lexus logo or heated seats

 

This is really nice. I would do it to mine for sure!

 

ha exactly :P

and i just taped up and tucked the power, o/d and traction control into the console. When I get more time i'm going to relocate them all to a toggle switch.