hope this is the right section... before OLT has my head...

Im trying to find the lug/thread size for the SC400 1996

I'm ordering a set of McGard Lug nuts and i have no freaking clue what the hell to order!

I did some searching but didnt find anything. Should I just go to autozone or something?

Here's what im looking at, Scroll all the way to the bottom

http://www.jegs.com/webapp/wcs/store...53340_-1_11611

 

M12 (12mm) x 1.5 Thread Size

 

Thank you very much sir!

 

I was trying to figure this out too but couldn't find it, but didn't want to make a thread.

 

hahaha, the funny thing is that i didnt have a clue either until i walked into a performance shop and purchased some lug nuts for my wheels!! lol!! and yeah, they did say 1.5 on them

 

What's the shank length needed if we're running a pass-through lugnut (i.e. Weld drag whels)?

 

If youre looking for locks on aftermarket wheels you do not want to get anything with shanks. Conicle seats are perfect for aftermarket wheels. The size and thread pitch you want to look for is 12x1.5

 

Thanks for the tip. I got the Acorn/conical set.