Power Windows won't work
#1
Driver
Thread Starter
Join Date: Dec 2007
Location: VA
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Power Windows won't work
I unplugged my battery a handful of times this weekend to do a stereo install, now i can't roll my passenger and two rear windows down from the driver's seat. the other windows do go down from their own doors.
anyone know how to fix this?
anyone know how to fix this?
#3
Driver
Thread Starter
Join Date: Dec 2007
Location: VA
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
#4
Driver School Candidate
Join Date: Apr 2008
Location: Ontario
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
#9
Lexus Champion
iTrader: (7)
Join Date: Mar 2008
Location: NorCal 2IS/BayArea
Posts: 1,800
Likes: 0
Received 0 Likes
on
0 Posts
Here is the procedure if you tossed your book away
Any time the battery terminal has been disconnected, initialize each door's power window after reconnecting the battery terminal.
1. Push the engine switch to select the Procedure "IG-ON" mode.
At this time, the driver's door power window switch illumination blinks.
NOTE: When the battery terminal has been disconnected, each door's power window switch illumination blinks.
2. Push the driver's door power window switch and lower the window halfway.
NOTE: When the battery terminal has been disconnected, push each door's power window switch and lower the window halfway.
3. Pull up the driver's door power window switch until the window closes, and hold it for more then one second.
4. Check for the proper operation of the "one-touch open and close" function by fully pushing the switch "DOWN" once and fully pulling the switch "UP" once.
NOTE: Jam protection function is enabled through the above initialization procedure.
1. Push the engine switch to select the Procedure "IG-ON" mode.
At this time, the driver's door power window switch illumination blinks.
NOTE: When the battery terminal has been disconnected, each door's power window switch illumination blinks.
2. Push the driver's door power window switch and lower the window halfway.
NOTE: When the battery terminal has been disconnected, push each door's power window switch and lower the window halfway.
3. Pull up the driver's door power window switch until the window closes, and hold it for more then one second.
4. Check for the proper operation of the "one-touch open and close" function by fully pushing the switch "DOWN" once and fully pulling the switch "UP" once.
NOTE: Jam protection function is enabled through the above initialization procedure.
Thread
Thread Starter
Forum
Replies
Last Post
shortbus19
IS - 2nd Gen (2006-2013)
8
12-20-11 09:25 AM