WELCOME.
I have a problem with electric power steering in the Lexus GS300 2006.
System indicator does not light up even in the moments after ignition, fuses are OK. Where is the power steering module ?? I looked next to the brake pedal but it is not there

Help

 

I Im having the same problem with mine right now too. think is located on top passerger side on dash but if replace it i think you have to activate according to the dealer I think its BS but not sure if tru though. I got to pay 1030 $ to fix it.

 

i went through an issue a few years back and i recall it being in the engine bay, drivers side. i could be wrong though. my comp at work crashed and i lost all my lexus files

 

The power steering ECU is located underneath the battery holder in the engine bay, you need to take the battery out and the battery tray and it should be right underneath. It should be held in place by three bolts, At least this is where alldata is telling me it is... but when I find a part that sounds related to power steering on parts sites, it shows something related to power steering under the passenger side dash so... I don't know, two different things perhaps?

It looks like there are two things "steering control ecu" and "power steering ecu"... so which one is bad?

 

WOW so there's two o god i cant believe this Is one power control and other for signal? Because the dealer tells me that its the Computer but I don't know to diagnose both internally.

"Madcap" how did you're steering system stop working? Let me tell you this my wife is pointing finger at me for car not working when I only re-calibrated the tire pressure on car.

Has anybody herd of this tire switch under the dash to have anything to do with the EPS?

 

i just had a problem with mine but it was because my wire harness had gone bad. I was replacing my pre cat O2 sensor and i guess a wire broke somewhere on the harness. they are EXPENSIVE to replace. better off looking online at the OEM lexus parts if it goes bad.

 

thanks for the reply
I found under the battery module is
Unfortunately, unless the ECU is damaged when the power is on line K, there is no voltage, CAN line on two of the four wires is 2.5 V

 

Plz let me know how your issue was resolved. Thx you