Installed a TOM’S throttle controller. I shortened the harness cause I hate having to coil wires that are too long.

 

I love how meticulous your work is.

 

Thank you!

 

 

I decided to put the clock back on, and did a little personal touch!

 

Switched out the Status seat for a Bride zieg, makes getting in and out of the car much easier with the shorter knee/thigh bolsters.

 

Some new carbon pieces showed up!

 

I'm anxiously waiting to be done with work because my wife just signed for these and they are sitting on the kitchen counter....lol..

Sneaky Ron, you didn't tell anyone you were buying these... I guess you saw the thread...lol looks like three of us has these now :-) I'll post pictures probably Friday or Saturday.

Make sure to post in the mirror thread as well.

These look wonderful. I was on the fence with them mainly because they are $800+ for such a small bit of CF.. but they do look splendid!

-Nigel

 

Yeah, saw it on FB and then here so I decided to get them. Way too much money for what they are though!

 

 

Time to lose more weight and show off the TRD rear partition brace! Rear seat delete. Removed the seatbelts and seatbelt pre-tensioners. Back cushion weighs 20lbs, bottom cushion is 19 lbs., seatbelt and related stuff weigh another 8lbs. Pre-tensioners, much like airbags, were replaced with resistors. Made some cardboard templates and now just trying to decide what material to use. It will be covered with lightweight carpeting material of course.

 

Got some .040" aluminum sheet and cut the rear seat delete panels. They will have some 1 inch dimpled holes to make them even lighter and stiffer. Just waiting for my dimpling dies.

 

Holes drilled and dimpled.

 

These will be painted and then maybe covered with automotive carpet material.