Got a full set of TE/FE brake calipers!







1.8mm hub shims needed to center the FIGS/RB ccm rotor to the new caliper.














Rear RB 380mm ccm pads fit perfectly. Even with the TE anti-rattle clips.




Onto the front:



Front pads, on the other hand, are just 5mm short.




pins line up.



So, to not waste the pads, I love ‘em BTW, I welded some 2.5mm stainless on each end of the pads.




Now they fit perfectly in the caliper.

Beautiful!

Thank you!

Got some colored center caps from Japan. Just something to change things up. add a little more
contrast. Easy to change back and forth. The yellow ones are for the IS F.

Never had the brake wear sensors mounted on the pads since I put the ceramic brakes on.







Short tunnel run

I've long since sold my RC-F but still come back here to see your beautiful machine. Stunning!

Thank you!

wow- fantastic job!!!

Thanks!! Appreciate it!

Finally decided to install the CF lower grill piece, got it off eBay pelted with rock chips, cleaned it up and refinished it with 2K clear. Also, installed some mesh behind the oil cooler grills and lower main grill. And obviously replaced some fasteners with titanium

Got the rest of the Ti and Al fasteners I was waiting for and finished re-installing the bumper cover!
cleaned up some wiring as well!


Before. Twisted, stressed wires.


After. Unplugged connector, untwisted wires, and tied neatly.

Simple swap, since I don’t need the seat memory buttons anymore. Interior door handle from TE/FE (thanks to @sensai for the info) And as usual, replaced fasteners with Ti and Al.

Yperion Titanium caps! Decals added for a little better look.

Holy canoli, you don't spare any expense for your car. It's almost like I'm looking at art I can't afford vs looking at a car. Absolutely incredible. I wish I could do what you do.