No spark no crank position sensor???
#1
Driver School Candidate
Thread Starter
Join Date: Nov 2011
Location: Pa
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
No spark no crank position sensor???
I have 94 sc300 GTE non vvti. It isn't getting spark or fuel. I can't find the crankshaft position sensor. It's not in the front of the block by the water pump/crank pully. Where could it be? Does it even have one? Could it be in the distributor or bell housing?
#2
The actual sensor is under the lower timing cover, wires come out somewhere around the alternator more or less behind it. It is a plug with two wires. Make sure you have power everywhere first before you think its the sensor, check power on coils, injectors etc... Hope this helps.
#3
Lexus Test Driver
Join Date: Aug 2011
Location: NM
Posts: 1,024
Likes: 0
Received 0 Likes
on
0 Posts
your car gets cam/crank info from the distributor. While the dist may have gone bad it's probably your ecu that failed. Ask me how I learned that lesson
Thread
Thread Starter
Forum
Replies
Last Post
Jamil518
Performance & Maintenance
8
03-22-16 03:14 PM