AEM UEGO install question
#1
Lead Lap
Thread Starter
iTrader: (3)
Join Date: Mar 2007
Location: louisiana
Posts: 547
Likes: 0
Received 0 Likes
on
0 Posts
AEM UEGO install question
ok I'm wiring in my wideband and mapecu at the moment.
The MAPECU software tells me how to wire up the ground, and the signal wire.
I assumed to run it on the same power wire as the map ecu. I'm hoping that it is ok, because there is no fuse there.
but my question is, what wire on the ecu do i hook up the "serial output" wire to on the wideband? That is the only wire not connected.
Also can anyone recommend a better power source if i installed the power wire incorrectly?
The MAPECU software tells me how to wire up the ground, and the signal wire.
I assumed to run it on the same power wire as the map ecu. I'm hoping that it is ok, because there is no fuse there.
but my question is, what wire on the ecu do i hook up the "serial output" wire to on the wideband? That is the only wire not connected.
Also can anyone recommend a better power source if i installed the power wire incorrectly?
Thread
Thread Starter
Forum
Replies
Last Post
1UZFE4ME
SC- 1st Gen (1992-2000)
10
03-19-13 06:59 PM
LasVegasGS
GS - 2nd Gen (1998-2005)
3
01-18-06 07:49 PM