Emblem/Badge removal
#1
Driver
Thread Starter
Join Date: Jun 2011
Location: HI
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
Emblem/Badge removal
Want to remove Both my Lexus emblems front and back and the IS250 badge to paint it. The best way is to use fishing line and goo gone right ? As for the IS250 badge are all the letter and numbers separate pieces ? What do I use to the emblems back ?
Does it look like this ?
Does it look like this ?
#3
Lexus Champion
iTrader: (2)
Heat it up a bit to make it easier... you can park outside on a hot sunny day or use a hair dryer.
Fishing line to slice thru it and goo gone to remove the left over residue.
To put the emblems back, use 3m double-side tape. Make sure to choose the thin strip so it doesn't bulge too much.
If you're planning to paint it, you can try to plastidip it as bob4256 said. It's much easier because you don't have to remove the emblems and re-attaching it when done.
Fishing line to slice thru it and goo gone to remove the left over residue.
To put the emblems back, use 3m double-side tape. Make sure to choose the thin strip so it doesn't bulge too much.
If you're planning to paint it, you can try to plastidip it as bob4256 said. It's much easier because you don't have to remove the emblems and re-attaching it when done.
#8
Driver
Thread Starter
Join Date: Jun 2011
Location: HI
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
They got this one.
http://www.acehardware.com/product/i...Id=54648188404
Idk, how im going to put it on though.
http://www.acehardware.com/product/i...Id=54648188404
Idk, how im going to put it on though.
#10
Pole Position
iTrader: (3)
Join Date: Mar 2012
Location: AZ
Posts: 246
Likes: 0
Received 0 Likes
on
0 Posts
A tip you can do and what I did. As long as you plasti-dip before. You can spray paint it what ever you want. I did mine in blue. It looks good IMO. And yes if you ever want it off. You can rub your fingers on it and rub it off just like plasti-dip. I'm doing my wheels a funky color here shortly. Just cause if I don't like it. I can peel it off.
#14
i removed alll my emblems too. i just used a plastic flat radio panel tool., i got all the emblems off in less than 30 seconds. then i cut out some black vinyl circles to go over the tiny holes that were left behind, from a distance you could not tell there are holes.
#15
Driver School Candidate
Join Date: Jul 2018
Location: Georgia
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post