Strut clearance
Thread Starter
2nd gear
Joined: Jul 2023
Posts: 2
Likes: 2
From: Nj
Strut clearance
Have been unable to remove a strut because the “axle carrier” or knuckle will not lower enough to allow for enough clearance to remove.
The bottom of strut is almost touching the axle boot. This doesn’t allow to find position to be able to bring out of the wheel well.
The car is a 2008 Lexus rx 350 AWD
The car is being held up by Jack on “rear suspension crossmember” could this not allow knuckle to lower enough?
Does anyone have advice?
I would be greateful for any advice
The bottom of strut is almost touching the axle boot. This doesn’t allow to find position to be able to bring out of the wheel well.
The car is a 2008 Lexus rx 350 AWD
The car is being held up by Jack on “rear suspension crossmember” could this not allow knuckle to lower enough?
Does anyone have advice?
I would be greateful for any advice
Thread
Thread Starter
Forum
Replies
Last Post
YODAONE
LS - 1st and 2nd Gen (1990-2000)
15
Nov 3, 2020 10:12 AM