I've searched but couldn't find any info anywhere on the proper head removal pattern and torque specs...

I'm in the process of putting a TT head gasket on and have never pulled a Head before, so if anyone has a link to some good info, please post it up!

Thanks alot.

 

 

Thanks Alot bro! Any Info on putting the head back on? the pattern and Torque specs?

 

No prob. Pm me an email address and I can get the whole cylinder head FSM section to you.

 

ssent the email earlier did you get it? That should help out a bit.

 

Yea man thanks alot. Has anyone here pulled the head studs out with just a 5 point hex socket? I've been looking for a ten point everywhere and cannot find one, the 5 point fits in there, I don't want to run the risk of stripping the bolt, but I'm running out of options here, I have ARP studs going in, just wondering if I can break the studs loose with a 5 point.... If it strips I'm F'd.