can some one please tell me the correct procedure to install the throttle position sensors , i have to replace both of them

 

anyone , please

 

Why do you have to replace both of them?

It's only two screws. Try and make sure you put the new sensor back in the same position as the old one. There is a voltage spec but I don't know what it is off the top of my head.

KC

 

it's gonna be kind tricky do adjust it if you don't have a scan tool

 

i found this DIY while surfing the net. It describes both the "book" method and the "backyard mechanic" method.

http://www.lexls.com/tutorials/EFI/tps.html

Im gonna try it once my car comes back.

 

Yah, I did my TPS adjustment just right around 600-650 and when I shift, the car doesnt vibrate when it's on gear either reverse or drive. My idle used to be really crappy like 200 vibrates like a message chair.
SMOOTH!

 

there is only one tps sensor on the car.....

 

Not if you have traction control.....


---------------------------------

You should be good adjusting the way shown in that link.

KC

 

thats your sub tps.....for trac not the tps input to the ecu