Power Windows Question
Thread Starter
Pit Crew
Joined: Nov 2014
Posts: 249
Likes: 9
From: CA
Power Windows Question
I have a dumb question for you all in this forum,
I can fully operate driver's side window with the master control located in the driver's side door.
When I push the button to lower the passenger's windows or any of the rear windows nothing happens. The front passenger and rear passenger can fully operate the windows with the switch located in each door.
Is there a setting that is preventing me from controlling the other 3 windows?.
I can fully operate driver's side window with the master control located in the driver's side door.
When I push the button to lower the passenger's windows or any of the rear windows nothing happens. The front passenger and rear passenger can fully operate the windows with the switch located in each door.
Is there a setting that is preventing me from controlling the other 3 windows?.
Driver
Joined: Aug 2004
Posts: 101
Likes: 1
From: Long Island, NY
Wow, can't believe no one's answered this yet.
Forward of the window switches, in the driver's door, are the master door lock sw and to it's right, the window lock out sw. This sw should be extended with a thin red band visible around the base.
If it's depressed (red band not visible), that prevents you from opening the other windows from the driver's position.
At least that's the case on our 2004 RX. And, yes, I just tried it .
Forward of the window switches, in the driver's door, are the master door lock sw and to it's right, the window lock out sw. This sw should be extended with a thin red band visible around the base.
If it's depressed (red band not visible), that prevents you from opening the other windows from the driver's position.
At least that's the case on our 2004 RX. And, yes, I just tried it .
Lead Lap
Joined: Aug 2013
Posts: 517
Likes: 13
From: Arizona
iluvny is for the the lockout...But your windows are not locked out. You need to go through the window reset procedure.
Go to the switch on each door and roll the window down.
Then pull the switch up to the second position (auto up) and hold it while the window rolls up and keep holding it for an additional one second after the window is rolled up.
Do this at all for doors and then your windows will work again.
Go to the switch on each door and roll the window down.
Then pull the switch up to the second position (auto up) and hold it while the window rolls up and keep holding it for an additional one second after the window is rolled up.
Do this at all for doors and then your windows will work again.
Lead Lap
Joined: Dec 2009
Posts: 445
Likes: 8
From: FL
iluvny is for the the lockout...But your windows are not locked out. You need to go through the window reset procedure.
Go to the switch on each door and roll the window down.
Then pull the switch up to the second position (auto up) and hold it while the window rolls up and keep holding it for an additional one second after the window is rolled up.
Do this at all for doors and then your windows will work again.
Go to the switch on each door and roll the window down.
Then pull the switch up to the second position (auto up) and hold it while the window rolls up and keep holding it for an additional one second after the window is rolled up.
Do this at all for doors and then your windows will work again.
Lead Lap
Joined: Aug 2013
Posts: 517
Likes: 13
From: Arizona
Every car I have ever owned that had on auto-up feature had to be reset after having the power disconnected. It makes sense that it has to be reset. The computer has to re-learn its limits so that it know the difference between a regular roll-up and a roll-up that has an obstruction (such as a child's arm).
Trending Topics
ClubLexus Stories
Celebrating Lexus & Toyota from Around the Globe
8 Tips for Improving Your Hybrid or Plug-in Hybrid's Efficiency!
Michael S. Palmer
10 Best Lexus Models No One Remembers
Joe Kucinski
TRD Off-Road Premium: Best 2026 4Runner, Except This One Thing
Michael S. Palmer
Top 10 Lexus & Toyotas to Drive Before You Die!
Joe Kucinski
Top 10 Lexus/Toyotas With The LEAST 5-Year Depreciation
Joe Kucinski
Lexus LC500 Convertible Auction: A Preview of Rising Values?
Brett Foote
GX 550 vs TX 550: Best 3-Row Luxury Lexus Family Hauler
Michael S. Palmer
9 Best Lexus Models You Can Buy for Half Price (And 1 You Shouldn't!)
Joe Kucinski
2026 Lexus NX Buyer's Guide: Models, Features, Prices & More!
Brett Foote
Driver School Candidate
Joined: Feb 2014
Posts: 13
Likes: 0
From: Ontario
I used the Driver's Side Window Lock on my 2005 RX330 to prevent my dog from lowering the window with her paw. But after I unlocked the switch, the only window I can operate is the driver's side window. Do you think this is the same problem as previously mentioned?
Thread Starter
Pit Crew
Joined: Nov 2014
Posts: 249
Likes: 9
From: CA
Follow the procedure and should be okay. I had the same problem
Thanks to everyone in this forum who answered my question.
Something tells me you either changed or disconnected the battery sometime around when you unlocked the switch.. Just guessing..
Driver School Candidate
Joined: Feb 2014
Posts: 13
Likes: 0
From: Ontario
Power Window Dilemna
Thank you for all the great advice!
I had forgotten that I had a problem with the battery being drained after I had the car serviced. They replaced the rear weatherstripping gasket, which prevented the door from closing completely. So I did get a boost from CAA. I didn't remember that part until you mentioned it.
Could I ask if there are any other occurances that I should know about? I must say none of my other vehicles did this.
Thanks every one for your input. I don't know how I would get by without this site!
I had forgotten that I had a problem with the battery being drained after I had the car serviced. They replaced the rear weatherstripping gasket, which prevented the door from closing completely. So I did get a boost from CAA. I didn't remember that part until you mentioned it.
Could I ask if there are any other occurances that I should know about? I must say none of my other vehicles did this.
Thanks every one for your input. I don't know how I would get by without this site!
Driver School Candidate
Joined: Feb 2014
Posts: 13
Likes: 0
From: Ontario
After receiving all the great replies with regard to the power window controls, I just started thinking about another electronic problem I have had with my 2005 RX330 since I got it about 18 months ago. I have referred to the manual many times, but I still have a bizarre time with my Moon Roof controls. There is no "One Touch" anything and the two buttons seem to be doing the same thing but not very well. For this reason, I really try to avoid using the Moon Roof as it is almost impossible to get it closed properly. Could some one please advise me if this is a reset problem, and if so, how do I reset it? Thanks so very much!
Moderator
Joined: Dec 2003
Posts: 3,283
Likes: 63
From: FL
Thank you for all the great advice!
I had forgotten that I had a problem with the battery being drained after I had the car serviced. They replaced the rear weatherstripping gasket, which prevented the door from closing completely. So I did get a boost from CAA. I didn't remember that part until you mentioned it.
Could I ask if there are any other occurances that I should know about? I must say none of my other vehicles did this.
Thanks every one for your input. I don't know how I would get by without this site!
I had forgotten that I had a problem with the battery being drained after I had the car serviced. They replaced the rear weatherstripping gasket, which prevented the door from closing completely. So I did get a boost from CAA. I didn't remember that part until you mentioned it.
Could I ask if there are any other occurances that I should know about? I must say none of my other vehicles did this.
Thanks every one for your input. I don't know how I would get by without this site!
The rear hatch might also become inoperative from the keyfob and might need to be reset. To do this, simply open and close the hatch manually.
Might be more but that's all I can recall I needed to do.
Driver School Candidate
Joined: Jul 2015
Posts: 2
Likes: 0
From: florida
Manual procedure doesn't work
Changed the battery and the drivers side window works but none of the other windows work. They don't work from the inidividual doors or drivers side control... Help