2001 rx 300 low beams not working.
#1
Driver School Candidate
Thread Starter
Join Date: Apr 2017
Location: WA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
2001 rx 300 low beams not working.
Could really us some help trying to get my low beams working. Have tested all fuses and tested and replaced all fuses and bulbs. Please help a brother out. Ty.
#2
Moderator
Try switching in/out of auto headlight mode. Not that it will cure your problem but it would check two different paths to activate headlights.
Switch out of auto and then start tracing 12v, starting from the headlamp socket back to the switch and then to the battery.
Salim
Switch out of auto and then start tracing 12v, starting from the headlamp socket back to the switch and then to the battery.
Salim
#3
Driver School Candidate
Thread Starter
Join Date: Apr 2017
Location: WA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Tried that all the way to the light sockets
Try switching in/out of auto headlight mode. Not that it will cure your problem but it would check two different paths to activate headlights.
Switch out of auto and then start tracing 12v, starting from the headlamp socket back to the switch and then to the battery.
Salim
Switch out of auto and then start tracing 12v, starting from the headlamp socket back to the switch and then to the battery.
Salim
#4
Moderator
Fog lights interact with high beam but having no bulb should not make a difference. Although my interest is peaked by why other circuits/loads are being questioned. Do we have other issues or lately some work has been done.
Who you say everything is good ,,, do you get 12v on the bulb socket? If so use a low wattage bulb like the done light instead of the voltmeter. If you have a bad connection, the voltmeter can show 12v but the wire can not sustain any current, a test bulb can verify that the current capacity exists.
Salim
Thread
Thread Starter
Forum
Replies
Last Post