Need help with two things
Thread Starter
Driver School Candidate
Joined: Aug 2004
Posts: 41
Likes: 0
From: Illinois
Need help with two things
1) I was able to install new blue lights low, high and the fog light near the wiper fluid. The one near the battery is giving me a hard time, i can not get it out. I pull up and it hits the top of the back plastic cover. I tried taking the socket out but it does not want to pull out of the light bulb (I do not want to pull too hard and break it) Any advise how to take that off.
2) The headlight covers I have look like they were replaced at some time. The beam is not heading where I need it. When I pull next to a car the drivers side beam is a bit low and to the right and the drivers side is too up (unless they are supposed to be like this). On my other cars I am able to adjest the beam by turning some screws. I was wondering if anyone can tell me where those screws are on a 2000 RX300 or better if they have a picture of the location of them.
Thanks
2) The headlight covers I have look like they were replaced at some time. The beam is not heading where I need it. When I pull next to a car the drivers side beam is a bit low and to the right and the drivers side is too up (unless they are supposed to be like this). On my other cars I am able to adjest the beam by turning some screws. I was wondering if anyone can tell me where those screws are on a 2000 RX300 or better if they have a picture of the location of them.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
tran20
ES - 1st to 6th Gen (1990-2018)
2
Jul 12, 2011 07:13 PM
wlee69
LX - 1st and 2nd Gen (1996-2007)
1
Jul 21, 2003 01:43 PM
