RX 300 clear corners... help
02-13-02, 10:31 AM
#17
Lexus Fanatic
Join Date: May 2001
Location: Connecticut
Posts: 5,145
Likes: 0
Received 0 Likes
on
0 Posts
Hendry, Looks very nice, good job.... I have a question for you. Where did you get those clear side markers. I really didn't care about them to much before but seeing yours and how nice it looks I want em too. So give up the Info....
02-13-02, 11:07 AM
#18
Pole Position
Join Date: Dec 2001
Location: Bellevue, WA
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
mrsypher, Thanks! I like them too... but I still put yellow bulb inside though...
I got them from Ebay for $32 + shipping, here's the link to one of the auction:
http://cgi.ebay.com/ebaymotors/aw-cg...987841&r=0&t=0
This seller have lots of them, so check it out...
I got them from Ebay for $32 + shipping, here's the link to one of the auction:
http://cgi.ebay.com/ebaymotors/aw-cg...987841&r=0&t=0
This seller have lots of them, so check it out...
02-17-02, 05:40 PM
#21
Rookie
Join Date: Jan 2002
Location: California
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
I just attempted to unscrew the drivers side. Getting my hand between the bumper and wheel well was fine. But that screw didn't come off when I tried to unscrew it with my hand. Anyone have any ideas or help?
*and I figured out what blocks it on the Passenger side. Its a tank. It holds some sort of blue liquid. Not sure though.
*and I figured out what blocks it on the Passenger side. Its a tank. It holds some sort of blue liquid. Not sure though.
02-18-02, 11:42 AM
#27
Rookie
Join Date: Jan 2002
Location: California
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
I installed them this morning. The directions helped alot. It took me about 5 minutes to do the Driver Side. and about 15 minutes for the Passenger side. I must say, you do need a small hand for the driver side. I have a big hand and barely got it.
-Use the 10mm tool in the tool kit, get the screw loose alittle bit, and unscrew it with your hand. Have patients. If you drop the screw or tool you are in trouble. I replaced the normal bulbs with blue bulbs.
-Use the 10mm tool in the tool kit, get the screw loose alittle bit, and unscrew it with your hand. Have patients. If you drop the screw or tool you are in trouble. I replaced the normal bulbs with blue bulbs.
