When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
After getting my GS430 back from the bodyshop will start working on my system I was thinking and go with one 12" IDMAX D4 or two JL 10W6V2 and run it with JL 500/1. My system goal is SQ only.
Which setup do you guys think I should go with???
Or any other suggestions?
2 10's will be louder
1 12 will play lower
IMO, I would run one W6 off that amp, for an SQ install, since 500 wrms isn't really sufficient to run the 2 W6's or the idmax to its full potential.
I have an idmax 12 in my garage and I'm still sticking w/ my 10's
The W6V2 is more of an SQ sub. The W7 will play louder for more SPL, but will not be as accurate at lower volumes due to its higher excursion suspension.
2 10's will be louder
1 12 will play lower
IMO, I would run one W6 off that amp, for an SQ install, since 500 wrms isn't really sufficient to run the 2 W6's or the idmax to its full potential.
I have an idmax 12 in my garage and I'm still sticking w/ my 10's
Absolutely. I would run ONE 12W6V2 for SQ, that'll be all you need and will work out well. If you want more SPL, then go IDMAX12.
The W6V2 is more of an SQ sub. The W7 will play louder for more SPL, but will not be as accurate at lower volumes due to its higher excursion suspension.
I beg to disagree, the W7 is QUITE accurate at even lower volumes. I've had both the W6v2 and the W7(current sub) and the W7 is by far more superior in sound quality.
2 10's sound better, crisper, and louder rather than 1 12" any day of the week. The reverberation of 10s are more noticable then 12" as well. Also depending on the amp used.