Performed IS250 Spark plug change.
02-28-17, 06:28 PM
#1
Driver School Candidate
Thread Starter
Join Date: Aug 2014
Location: CA
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Performed IS250 Spark plug change.
It was a success! But now Driver window panel does not work for any other windows. I only could control my window side. Has this happened to anyone else? Please help me trouble shoot! Yes I removed the battery when I performed this.
02-28-17, 06:40 PM
#2
You can find this in the sticky section but here you go
https://www.clublexus.com/forums/is-2nd-gen-2006-2013/291026-electrical-help-windows-won-t-roll-up-after-battery-disconnect-2.html
https://www.clublexus.com/forums/is-2nd-gen-2006-2013/291026-electrical-help-windows-won-t-roll-up-after-battery-disconnect-2.html
02-28-17, 06:42 PM
#3
Gonna go off memory here...you have to reprogram your window. Press start button but don't turn engine on.
Roll drivers window half way down (not with automatic lower) but with your finger controling power...roll back up and hold for 3 seconds
Reach over to passenger window..this time roll all the way down...then back up....keep holding button up for 3-5 secs...
Repeat with other two windows..
You have to use each window switch from the door its on...then youre set
Roll drivers window half way down (not with automatic lower) but with your finger controling power...roll back up and hold for 3 seconds
Reach over to passenger window..this time roll all the way down...then back up....keep holding button up for 3-5 secs...
Repeat with other two windows..
You have to use each window switch from the door its on...then youre set
03-03-17, 02:13 PM
#6
OP said they "removed" or disconnected the battery when doing this DIY project. Since the battery feeds all of the various ECUs in the car their power when off, the memory of the auto-down/auto-up function is lost every time you disconnect the battery from the car..
Thread
Thread Starter
Forum
Replies
Last Post