Window Reset/Reprogram?
Thread Starter
Driver School Candidate
Joined: Jul 2010
Posts: 30
Likes: 0
From: North Carolina
Window Reset/Reprogram?
So my battery died the other day and ever since then I can't control the passenger windows in my car from the drivers door, but the individual switches work on each door. I was wondering if there's something I need to do to reprogram the switch to work again? I remember having to do something like that on my Mercedes once but I can't find anything about it for my Lexus. Has anybody ever heard of this? Car is a 1995 btw.
Lead Lap
Joined: Jan 2007
Posts: 683
Likes: 3
From: UK
I think this is correct
Turn on your Ignition.
Open your window half way down (approximate)
Press and hold the auto-up button until window closes.
Continue holding the button for a few seconds and release.
Confirm it works by testing the auto-up/down window button.
Turn on your Ignition.
Open your window half way down (approximate)
Press and hold the auto-up button until window closes.
Continue holding the button for a few seconds and release.
Confirm it works by testing the auto-up/down window button.
Driver School Candidate
Joined: Mar 2011
Posts: 16
Likes: 0
From: Ca
I tried that and it's not working, I've been searching for a solution and can't find it. Anyone care to direct me in the right direction? There must be a way to reset the window ecu, like a sequence of some sort
Driver School Candidate
Joined: Mar 2011
Posts: 26
Likes: 0
From: Pa
I've got kind of the same problem, but my passenger switches don't work. Sometimes the window will go down a inch or two but much slower. I can control the windows just fine from the drivers door. Thought it was a motor issue but than how could I put em up and down from my side. I've replaced the whole window/lock control, checked over all the wiring but they still don't work in all 3 passenger doors.
Thread Starter
Driver School Candidate
Joined: Jul 2010
Posts: 30
Likes: 0
From: North Carolina
I've got kind of the same problem, but my passenger switches don't work. Sometimes the window will go down a inch or two but much slower. I can control the windows just fine from the drivers door. Thought it was a motor issue but than how could I put em up and down from my side. I've replaced the whole window/lock control, checked over all the wiring but they still don't work in all 3 passenger doors.
Anyway, turns out its definitely not a programming issue, because now the drivers door switches occasionally work, mostly when the car has been running for a while. Any advice?
Thread
Thread Starter
Forum
Replies
Last Post
