What is the difference between the R face and the RR face? My rear 19x10 R face is pretty concave...

 

I dontt hink weds would make it the same concave if they didnt have a R and RR spec.

 

that is haaard!!
I think thats the way im gonna go..
any fender work on the fronts or just camber?
what tire size are you running?

 

tyre sizes

215.40 front
225.40 rear

the front fenders are rolled to the high heavens plus that bumper bracket has been hammered flat as possible. fender liner has baically been ripped out.

camber is organic camber at about 1.5 to 1.7 fronts and about 4.5 rears. i wanted more on the front but the IS does not have factory adjustments for them.

its alot of work to get them to fit.

 

ok, I appreciate the info and thanks for your time!! Im gonna look into this set up...

 

i will be putting on my set of SA55M 18x9 +36 all around (pretty conservative) next week so i can post pics when theyre done so we will be able to do some comparisons with integlspwr

 

Will 19'' 9.5 +45 with a 225/35 fit? is that too much of a stretch?

 

18x9 +36? sounds like sunken battle ships.

 

no thats perfect

 

So no one did a 18x10.5 +22 front ?

 

no cause thats gnarly dude hahaha, just pull like crazy

 

damn cause its actually 3mm LESS agressive than my 18x10 +18 setup.

Im just worried the extra half inch might hit some suspension component..

 

I'm pretty sure it'll be 3mm more aggressive. You should try it though. Just put your rears in the fronts and see how that goes

 

Well it's not gunna be 1/2" more in on the inside. It'll be about 2mm more aggressive out word with roughly 1/8"-1/4" in more on the inside

 

18x9 +20 front rear , need fender mod? 1 finger gap.