AGGRESSIVE ISX50 wheel thread
I installed on my IS ASA wheels which are heavy and they wight about 27lbs X_X I feel it's too much. I'll plan on getting the VOLK TE37s after installing exhaust system, front lip and rear spoiler.
They just make me want them by looking at 2 pictures posted in the first page...
They just make me want them by looking at 2 pictures posted in the first page...
So far it looks like mr mark has the most aggressive set up...
19x9 +22 2
25-35-19 Kumhos
19x10 +22
235-35-19 Kumhos
How much mods to your fenders were needed? Front? Back?
19x9 +22 2
25-35-19 Kumhos
19x10 +22
235-35-19 Kumhos
How much mods to your fenders were needed? Front? Back?
can i post up in here now?
this is my daily ride height...the closest you can get without rubbing on stock fenders
you probably can go lower offset if you have a smaller tire and not dropped as low
19" +43 with a 275/30 tire slammed on JIC

Edit: you can see that i'm super close, but the tire shows no indication of rubbing xD
this is my daily ride height...the closest you can get without rubbing on stock fenders
you probably can go lower offset if you have a smaller tire and not dropped as low
19" +43 with a 275/30 tire slammed on JIC

Edit: you can see that i'm super close, but the tire shows no indication of rubbing xD
Tire size on the front, I'm not sure. The rear setup is basically the same as Mr Mark.
I believe pulling of the front and rear was required. Not enough to warrant body work or painting, though. You can see more pics on AME wheels website under the news section. Mr Marks car is right there too.
I believe pulling of the front and rear was required. Not enough to warrant body work or painting, though. You can see more pics on AME wheels website under the news section. Mr Marks car is right there too.
Tire size on the front, I'm not sure. The rear setup is basically the same as Mr Mark.
I believe pulling of the front and rear was required. Not enough to warrant body work or painting, though. You can see more pics on AME wheels website under the news section. Mr Marks car is right there too.
I believe pulling of the front and rear was required. Not enough to warrant body work or painting, though. You can see more pics on AME wheels website under the news section. Mr Marks car is right there too.
19x9.5 +22
19x10.5 +22

Actually... technically, this has the most aggresive setup.



