Haha, it will have to wait until Thursday night or Friday now. I dropped my car off at the dealership a couple hours ago to get some work done. Remind me and I will take a picture when I get it back.
If anyone else wants to run out and take a picture of it for this person that would be great too.

 

I am in Taiwan also, and tried it with my building's system... unable to get it to work in any way.

In a preliminary attempt, I took apart the homelink system and rewired the buttons to control the remote, which I also took apart and fit into the panel itself... everything works smoothly now...

In my next version, I will take two remotes (one from my place, one for my gfs place), take them apart, calculate the required power supply for each remote and feed power directly from the car (no need to ever replace batteries), hijack the buttons from the homelink system and hardwire them to each button on the remote, and use the circuitry to open/close my garage (buttons 1 and 2) and to open my gfs (button 3)

It's a bit of a waste to ruin a completely decent homelink IC board but unfortunately seems useless in taiwan.

 

I have an 07 LS460 and was at wits end trying to program my homelink to my garage door opener.I must have tried over a dozen times including trying the rolling code. Finally I read on a thread that on some cars the car has to be running so I tried it and it works.
I started with my remote close to my Homelink and pressed the homelink button and the garage door opener remote at the same time. I then went to the garage door opener learn button and pressed it then quickly went back inside the car and pressed the Homelink button and voila.......my garage door opened.

 

Think you for all the great posts, I'm new, but plan to use the forum as much as i can.