Peeling off
02-13-19, 06:12 PM
#1
Pit Crew
Thread Starter
Peeling off
The trim on both side of back up screen , looks like fake wood , sotr of.
And around handle used for changing gears from D to R and so on
What are you al using as , I guess glue , to re glue it back down ??
Thx
And around handle used for changing gears from D to R and so on
What are you al using as , I guess glue , to re glue it back down ??
Thx
02-13-19, 07:01 PM
#2
My wood trim started peeling off near the nav unit. I just super glued it back down. It’s been about 6 months. Temps have gone from 100+ in the summer to -10 degrees in the winter and it’s held up just fine. Hardest part was taking it all apart.
02-15-19, 12:14 PM
#3
Pit Crew
Thread Starter
Taking what all apart ?
The sharp pointy edge next to the nav is barely coming off , really see no reason to take any thing off
Super glue , of course , thanks
The sharp pointy edge next to the nav is barely coming off , really see no reason to take any thing off
Super glue , of course , thanks
02-15-19, 01:25 PM
#4
Same. The top corner was barely out. I took the piece off because I didn’t want to get super glue all over my dash and nav. I also used a clamp to let it set properly before I put the piece back on.
02-15-19, 05:52 PM
#5
Pit Crew
Thread Starter
I purchased some SG , thanks to you , I am not removing anything , a few drops and hold down for 30 seconds as written in the directions , I might even hold it for a minute .
same with the plastic around the hi low ****
same with the plastic around the hi low ****
Thread
Thread Starter
Forum
Replies
Last Post
vfr700f2
LS - 3rd Gen (2001-2006)
3
05-16-17 08:16 AM