Back up light, plastic cover removal
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2013
Location: Ontario
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Back up light, plastic cover removal
Noticed that my drivers side back up plastic cover is cracked with a small hole in the top.
Anyone know how to remove this piece?
Would like to RTV the damaged area to seal it but I need to remove it to make the repair.
I've pulled some of the inner plastic on the door but can't get at the back up plastic cover.
Let me know if you have done this and how
Any directions would be appreciated.
Anyone know how to remove this piece?
Would like to RTV the damaged area to seal it but I need to remove it to make the repair.
I've pulled some of the inner plastic on the door but can't get at the back up plastic cover.
Let me know if you have done this and how
Any directions would be appreciated.
#2
Noticed that my drivers side back up plastic cover is cracked with a small hole in the top.
Anyone know how to remove this piece?
Would like to RTV the damaged area to seal it but I need to remove it to make the repair.
I've pulled some of the inner plastic on the door but can't get at the back up plastic cover.
Let me know if you have done this and how
Any directions would be appreciated.
Anyone know how to remove this piece?
Would like to RTV the damaged area to seal it but I need to remove it to make the repair.
I've pulled some of the inner plastic on the door but can't get at the back up plastic cover.
Let me know if you have done this and how
Any directions would be appreciated.
You have to pull the door trim and then pop all of the clips. There is a DIY on the forum. Search you will find it. I did it and its a pain to remove the back up light assemble even after you get the panel off. I had to replace the lens it was to badly cracked and was leaking
Thread
Thread Starter
Forum
Replies
Last Post
tsxnbp
LS - 1st and 2nd Gen (1990-2000)
0
06-19-15 04:25 PM