When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
You are missing key information (width and offset) for most of us to give you an opinion. FWIW, that tire size in the rear usually would need a fender roll or shave as I' guessing the rim is more than likely a 20x10.5 or wider.
Thank you for that. I'll try to get that info. I appreciate you taking the time to help me out.
Are you rubbing at all? And any spacer? Im looking for help if you can im trying to get xxr 968 20x9 front and 20x11 rear what off set? Drop 1 in and maybe fender roll
Are you rubbing at all? And any spacer? Im looking for help if you can im trying to get xxr 968 20x9 front and 20x11 rear what off set? Drop 1 in and maybe fender roll
What XXRs are you going to get? I have some Work SC-1s in 20x9 +35 and 20x10.5 +40 that i will sell for fairly cheap. Rears will sit pretty flush but if you really want spacers, i have some 15mm ones too.
Hello guys,
First let me say hello I am new to this forum and owning a Lexus. I love the car so far and have been reading all the threads here. This wheel thread is awesome but I was unable to find the answer to my question. Can anyone tell me what the recommended wheel size and tire sizes are for a 2008 GS350 AWD? I would like to go to 20's possibly if I can. I do not want to deal with rubbing or bottoming out. As of right now I do not plan to lower the car. I also do not want to mess up the AWD. Any help/ideas would be greatly appreciated.
Thank you
Wes
Same question as ⬆️ Just bought a 2007 AWD 350. Keeping a stock suspension- I just want a wheel w/a deep lip, any offset help would be appreciated.
Weds Kranze Vishunu
Front: 19x8 +50 with 5mm spacer, 245/35/19 Hankook Ventus Evo 2
Rear: 19x9.5 +44, 275/30/19 Hankook Ventus Evo 2
Tein Comfort Sport Coilovers w/ 1.8" drop F/R
No fender mods and no rubbing
question of the fitment gurus. i just picked up a set of work euroline dz in 19x9 +25 and 19x10 +20. Fronts are A disk, and rears are O-disk. Just went to test fit them, and the rears stick out just a tad bit, but I'm pretty sure when I drop the car more, and shave the rear fender, it should be good.
I'm more worried about the front, as the A-disk does not clear the caliper, and they are sticking out quite a bit as is, before a spacer. I haven't had a chance to grab spacers but I'm assuming a 10mm is in order, essentially putting the front offset at +15. Is this doable with just a roll? Thanks!
19x9.5 +14 235/35<br/>19x11 +25 255/35<br/><br/>Front scrapes when hitting bumps and turning.. <br/><br/>I believe its rubbing the metal tab in the far top corner near the bumper. Anyone familiar with this and any tricks to get it to stop? <br/>
