My Aristo Single Turbo Project
Thread Starter
Driver
Joined: Jan 2012
Posts: 156
Likes: 1
From: New Zealand
I did the chassis mods and sway bars at the same time, so hard to say - but overall a big improvement and would highly recommend!
Thread Starter
Driver
Joined: Jan 2012
Posts: 156
Likes: 1
From: New Zealand
Slightly bigger update - head has come off, everything is nice and shiny now, head gasket replaced, ARP head studs added, valve stem seals replaced, and the HKS cams will soon have a nice new home:
Thread Starter
Driver
Joined: Jan 2012
Posts: 156
Likes: 1
From: New Zealand
Another update, went by to Soichi's today, to check out progress - things are coming along well!
Head is installed, manifold and turbo have been bolted up, intercooler has been installed, as have trans cooler and engine oil cooler!
Head is installed, manifold and turbo have been bolted up, intercooler has been installed, as have trans cooler and engine oil cooler!
Thread Starter
Driver
Joined: Jan 2012
Posts: 156
Likes: 1
From: New Zealand
Another update - intake manifold back on with new 850cc injectors and Tomei FPR, and both the engine oil cooler (wing mounted shown) and transmission cooler (front mounted) have been hooked up.
Thread Starter
Driver
Joined: Jan 2012
Posts: 156
Likes: 1
From: New Zealand
Update time!
Pretty much all the mechanicals are done now apart from catch can and a few odds and ends - and the obvious missing radiator, which I have been promised will be in country next week.
Pretty much all the mechanicals are done now apart from catch can and a few odds and ends - and the obvious missing radiator, which I have been promised will be in country next week.
