Im having a very difficult time pushing the knuckle bushing in place for the LCA , I have c- style ball joint press . And bolt+washer setup. The bushing just keeps moving out of place.......

I am currently freezing the bushing, I will be using an impact driver on the bolt+washer setup. I am also considering blow torching the knuckle a bit.
Third bushing to try-Dorman from Rockauto.

ALSO BUSHING HAS IDENTIFIED ANGLED ENDS I AM PLACING -GROOVED END IN TOWARDS AXLE.

 

I’m assuming your talking about the rear. I bought the Spc balljoint kit from Figs. I had originally rented one from the autoparts store but it didn’t work for me