PPE Headers
Thread Starter
Rookie
Joined: Apr 2012
Posts: 86
Likes: 2
From: CA
After a one-month follow up, I began to notice a rubbing issue on right hand turns as previously noted by SlvBullet. For me personally, it happens on slow, sharp right turns only.
I havn't posted a video of the exhaust note with the headers, but I'll try to do so asap.
I havn't posted a video of the exhaust note with the headers, but I'll try to do so asap.
Its the sharp turn - grind a bit off the edges of the steering knuckle and you should be fine.
Pit Crew
Joined: Jun 2025
Posts: 177
Likes: 9
There are no issues with these headers. No check engine lights, or valve clicking. It will be a little louder, but not much if you retain your stock cats.
Install isn't too bad, about 8 hours is all it will take with a lift and the proper tools. The hardest part is getting the factory heat shields out. Install is simple.
Install isn't too bad, about 8 hours is all it will take with a lift and the proper tools. The hardest part is getting the factory heat shields out. Install is simple.
CL Community Team
Joined: Dec 2024
Posts: 1,838
Likes: 558
From: PNW
The post was from Jul 2014 — he must’ve had a heck of a time removing those heat shields as mentioned, but afterwards sounds like it went fairly easy and less time consuming.
Pit Crew
Joined: Jun 2025
Posts: 177
Likes: 9
Yeah I guess so hahaha. I just cant imagine it taking that long to remove headers even with difficulty removing the heat shield. Been debating getting the headers but if it takes them 8 hours with a lift itd take me a lot longer than that
Thread
Thread Starter
Forum
Replies
Last Post
GrantReid
SC - 1st Gen (1992-2000)
9
Oct 11, 2017 11:44 AM
MileHIFcar
IS F (2008-2014)
22
Jun 13, 2016 03:13 PM
