Help - Hydraulic clutch / Input Shaft quesiton

Reply Subscribe

Thread Tools

Search this Thread

Aug 18, 2016 | 09:45 PM

macna

Thread Starter

Driver School Candidate

Joined: Oct 2012

Posts: 22

Likes: 0

From: TN

Help - Hydraulic clutch / Input Shaft quesiton

Hey Guys,

I don't want to jump the gun and say that I've been had, so I want to check to make sure of a few things.
The T56 style throw out bearing doesn't seem to fit over the input shaft. It's just not going to go without some abusive and possibly destructive tapping. Are people just forcing this on there?

Any options out there for a hydraulic throw out bearing that will work with the 5/8 clutch master cylinder?

In context, this is for a 1uz to W58 swap.

Aug 18, 2016 | 10:39 PM

salimshah

CL Community Team

Joined: Apr 2001

Posts: 16,533

Likes: 1,379

From: Austin, TX

Was't there cutting of the collar in one of the conversion thread?
Shaft should pass through and the collar is trimmed back.

I would also try to position the slave with the bleeder tube pointing up to purge the air out quicker.

Salim