Spacer solution needed
Thread Starter
Driver School Candidate
Joined: Aug 2010
Posts: 41
Likes: 0
From: Ga
Spacer solution needed
Been riding around on is300 17's since I picked up my sc a few months back. About to slap my coils on but i'm sure it'll look horrible with th is3's on lowered. Need some spacer suggestions till I get my wheel money together. Is3's are 17x7. Im thinking half inch in the rear and 1 inch up front maybe?
Last edited by ArTofSoaR; Jul 9, 2011 at 04:53 PM.
Driver
Joined: Jan 2011
Posts: 152
Likes: 0
From: Kansas
quick n dirty bro figure out the offsets.....
-60mm offset= tucked in
-0mm offset= poking out
-35mm offset= closer to flush but not quite....
these are examples by the way soooooo figure out your offsets and go from there... good luck
-60mm offset= tucked in
-0mm offset= poking out
-35mm offset= closer to flush but not quite....
these are examples by the way soooooo figure out your offsets and go from there... good luck
Thread Starter
Driver School Candidate
Joined: Aug 2010
Posts: 41
Likes: 0
From: Ga
I'm not trying to make stockies look anything. Im saving up for wheels and i'm tired of stepping over this big box of coils sitting in my living room.
Last edited by ArTofSoaR; Jul 10, 2011 at 06:31 AM.
Thread
Thread Starter
Forum
Replies
Last Post
