...but from downunder!

 

Satin Black Vinyl spray, black microsuede retrim on the lower door pods. New carpet in charcoal (E-Bay), new Momo wheel, E-Bay hand break cover and shifter. Window and console controls all sprayed satin black, and relabelled with Barry's Model lettering, 3pt, Arial font. http://www.modellettering.com/

 

Looks 2009+ brand new

 

lettering redone with vinyl letters noted before

 

looks good man A+ was it difficult to instal the shifter ?

 

As long as you're not too squeamish about applying an angle grinder to your car - then no!

I had to make the shaft rounder to make the new **** fit (the **** hole is round, while the Toyota shaft is kinda oval) and about 1 inch shorter - so it didn't look odd.

So 10 minutes with the angle grinder, lots of sparks and nervous sweat and it was done.

I slid a short length of black plastic tube over the shift shaft and pushed it down.

Slid the shift **** over the butchered shaft and tightened the three grub screws supplied at an appropriate height - took a minute to find the level at which it worked properly.

Slid the plastic tube up to cover the screws.

that's it...

$25 or so......

 

I forgot, I relocated the overdrive switch to the gearshift surround. I used a spare Toyota switch and relabelled it o/d norm.

 

Nice work!

 

SCWEEEEET! that looks showroom new.

 

nice and fresh looking! good job...

 

I agree, that is some nice work! Turned out nicely!

 

that is niiiice

 

ideas ideas...

...oh - did you put some type of clearcoat on top of the controls after the lettering job?

 

^^^^ LoL that is a good question..... can you post a pic of the relocated o/d button

 

Is that a 2010? LOL! Very nice indeed