has anyone straight piped an sc400? im looking to put in a x pipe and doing 2.5 inch pipe, maybe even 3 inch pipe,

i was planning on cutting right before sub catalitic converter,

im worried about low end power loss though, would i lose some low end straight piping 2.5, or 3 inch

 

Magnaflow 14829 mufflers i believe they r 3.5" tips:
http://www.youtube.com/watch?v=QQwEoxli3vo

 

http://www.youtube.com/watch?v=V6E0QrY1XCE

 

2.5" cat back to dual apexi n1's

 

Anyone have an idea of what exhaust this may be?

http://www.youtube.com/watch?v=v_E6KL33ArQ

 

Well I went to go build an exhaust today. They had it in the air and the first thing they said was I wouldnt even touch this exhaust its beautiful (the stock). But What I told them I wanted was a 2.5 inch cat back into a magna flow with 3 inch tip single. Exit. Iv heard many good things from a single exit. Such as lighter, Better air flow, and cheaper.

Another muffler shop told me I should keep my stock piping and just do an axle back 2 new mufflers with some 3 in tip if I want.

What should I do that cost effective and good.

 

i took out the mufflers and resonators and ran straight pipe to stock tips on my 400. sounds good to me. im happy with it.

 

hks hi-power gutted cats 3" ss to header



http://www.youtube.com/watch?v=drxZr4TuCYs

 

IV wondered this. Why would people run 2.5 cat back piping when its already 2.5 inch?? Whats the point? I understand getting a cat back exhaust if your going 3 or whatever. Im assuming piping is just piping? And nothing would change unless you plan on doing an x pipe?

 

Some good looking exhausts, but guys please protect yourselves and blur out your license plates..

 

I played all 3 vids at the same time and turned the sound up OMG SICK!!

 

^ hahaha

my plates i don't mind since its not like you can't see my plates when im out in public anyway

 

I just think thats for people who don't have a life to be running plates , NA right? do you have a resonator in it?

 

Below is pics of my exhaust upgrade. I purchased the following from P2R and then brought it to Florida Performance mufflers in Fort Lauderdale for a custom Mandrel bent install. The result was a solid very deep tone stright through exhaust system. I am very pleased with the parts, workmanship,and prices.
2 vibrant mufflers
1 Vibrant resonator
2 Vibrant oval tips
2 stainless steel y pipes

 

^^^^Wow that's very nice work. Hope you post a sound clip.