and pics

 

glass goes in tommorow. the guages are the new STRI guages. made by guys that i heard used to work at Defi. awsome in look and price and you dont need a main module to do them you can do just one guage

 

Looking good so far, I like the gauge setup. I can vouch for Phoenix Tuning's work they did an excellent job on my buddy's harness for his gte swap. I will be sending down mine to get done soon also.

 

pic build. a little off topic....what kid of mirrors are that on the red sc in your photobucket folder?

 

bomex mirrors.want to buy them

 

i would be interested. how much? oh what kind of motor is that in the corner that you can see in one of the pics? is that a nissan CA or RB? kinda looks like it. good build i like. keep it up.

EDITED: it my 100th post

 

The gauges and gauge pod look fabulous!

Want to make me a set?

Rest of the car/swap looks awesome as well!

 

as for the mirrors, you name a reasonable price shipped.keep in mind they are the power set.

the engine in the corner is a built rb25 for my buddys car

and the guage pod yes but its not chep. about 250 built and painted and you have to suply the full wood grain all around.

 

as for the emanage were you able to setup the high/low impedence for the US injectors without a resistor pack? im onl asking cause im in the same situation.

 

no but i did get the resistor pack and found out that i could have made it myself for half the price.pm me if you want one

 

You got PM

 

I've been watching your swap and wish you luck on the 500hp. I am planning this swap and hope to accomplish the majority myself. Did you have to change the crossmember or just the motor mounts and brackets.

 

just motor mounts swapped for the TRD ones. The glass went in yesterday and its lookin like a car again

 

car looks sick (subscribed)

 

what kit?

matt