Lower arm - spacer/shim location
Thread Starter
Driver School Candidate
Joined: Aug 2016
Posts: 1
Likes: 0
From: OK
Lower arm - spacer/shim location
First, thanks to all on the board. It and everyone has been a big help. I recently bought a 99 RX300 FWD and am in the process of chasing down gremlins and repairing a few things.
I have removed the front lower arm on the driver side. However, I didn't notice the shim/spacer that fits on one side of the bushing that bolts to the frame until it was laying on the ground. Can someone tell me whether it goes on the front or rear bolt?
Again, thanks for the help!
I have removed the front lower arm on the driver side. However, I didn't notice the shim/spacer that fits on one side of the bushing that bolts to the frame until it was laying on the ground. Can someone tell me whether it goes on the front or rear bolt?
Again, thanks for the help!
CL Community Team
Joined: Apr 2001
Posts: 16,570
Likes: 1,393
From: Austin, TX
Welcome to Club Lexus.
Are we talking about the washer that has the markings?
Check the other side ... hopefully that is still fully assembled.
Hopefully you marked the spot before taking it off.
Salim
Are we talking about the washer that has the markings?
Check the other side ... hopefully that is still fully assembled.
Hopefully you marked the spot before taking it off.
Salim
Thread
Thread Starter
Forum
Replies
Last Post
sphy1005
SC - 1st Gen (1992-2000)
9
Dec 29, 2005 07:15 PM