Changing AT Fluid

Reply Subscribe

Thread Tools

Search this Thread

Oct 8, 2006 | 03:21 PM

landarc

Thread Starter

Driver School Candidate

Joined: Dec 2004

Posts: 49

Likes: 0

From: Canada

Changing AT Fluid

Hi. I am about to change my AT Fluid based on the DIY website: http://lexusmodz.netfirms.com. He recommends using a new crush washer (P/N 35178-30010 or P/N 35178-50010). Should I get a new one or can I reuse the same one? Any recommendations?

Thanks.

Oct 8, 2006 | 06:27 PM

GSteg

Rookie

iTrader: (15)

Joined: Jul 2005

Posts: 16,018

Likes: 81

From: CA

I was able to reuse mine, but I limit the washer to only 2 intervals before I change out for a new one.

Oct 11, 2006 | 07:46 AM

PRSUIT460

Racer

iTrader: (3)

Joined: Oct 2003

Posts: 1,467

Likes: 16

From: Wisconsin

You can re-use the old one but I would use a new one since they are cheap and it will prevent a leak.

Oct 11, 2006 | 08:37 AM

bmgs400

Lexus Champion

Joined: Nov 2003

Posts: 1,691

Likes: 0

From: St. Petersburg, Florida

I did my own tranny fluid change several times (around 10 times) and never had replaced the washer. A snug fit is all you need so then the washer can be reused with out risk of leaks.

Oct 11, 2006 | 12:13 PM

chuckb

Lexus Fanatic

Joined: Aug 2004

Posts: 6,947

Likes: 4

From: Florida

re used mine no prob.

Oct 11, 2006 | 06:40 PM

landarc

Thread Starter

Driver School Candidate

Joined: Dec 2004

Posts: 49

Likes: 0

From: Canada

Thanks for all the advice. I am going to buy a new one on Saturday and change it this weekend. Hope it stays warm. It is going to 4 degrees celcius. Brrrrrr!