Picture Request: Vacuum lines
#1
Picture Request: Vacuum lines (SC300)
Hello,
I tried asking in an old post about P0401 codes but it just gets lost in the shuffle.
Can someone please take 10 minutes to go take a picture (or two) of the vacuum line area WITH camera flash on and post them over? SC300 please.
I swear my vacuum lines are hooked up wrong giving me an EGR code based on the routing chart, but then again my engine was swapped with a Japan GE without EGR and I had to "add" it back and I think the lines are wrong. My old pictures show two "T" lines from the plenum vacuum port near the EGR but now I only have one.
Thank you, (tired of getting 12MPG!)
I tried asking in an old post about P0401 codes but it just gets lost in the shuffle.
Can someone please take 10 minutes to go take a picture (or two) of the vacuum line area WITH camera flash on and post them over? SC300 please.
I swear my vacuum lines are hooked up wrong giving me an EGR code based on the routing chart, but then again my engine was swapped with a Japan GE without EGR and I had to "add" it back and I think the lines are wrong. My old pictures show two "T" lines from the plenum vacuum port near the EGR but now I only have one.
Thank you, (tired of getting 12MPG!)
Last edited by ISFFUN; 06-01-15 at 11:10 AM. Reason: title
#6
Driver School Candidate
isffun did you ever find some images to fix this issue. I am trying to figure out this rattling problem So I took everything off and did a tune up while I was there and now the lines are out of order.
Thread
Thread Starter
Forum
Replies
Last Post