SC3 not entering diagnostic mode
#1
Rookie
Thread Starter
Join Date: Oct 2001
Location: Maryland
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
SC3 not entering diagnostic mode
my sc3 failed smog because it would not go into diagnostic mode during the ignition timing test. jumping the te1 and e1 terminals is supposed to bypass the ecu so it doesn't auto-adjust the timing.
but even after short-circuiting those terminals, the ecu brings the rpm back to 700 no matter how i adjust the distributor. how can i get the diagnostic mode to activate so i can pass smog? help!
but even after short-circuiting those terminals, the ecu brings the rpm back to 700 no matter how i adjust the distributor. how can i get the diagnostic mode to activate so i can pass smog? help!
Thread
Thread Starter
Forum
Replies
Last Post