DRFT103

iTrader: (3)

I've searched but couldn't find any info anywhere on the proper head removal pattern and torque specs...

I'm in the process of putting a TT head gasket on and have never pulled a Head before, so if anyone has a link to some good info, please post it up!

Thanks alot.

GSXRMack

iTrader: (3)

DRFT103

iTrader: (3)

Thanks Alot bro! Any Info on putting the head back on? the pattern and Torque specs?

GSXRMack

iTrader: (3)

No prob. Pm me an email address and I can get the whole cylinder head FSM section to you.

GSXRMack

iTrader: (3)

ssent the email earlier did you get it? That should help out a bit.

DRFT103

iTrader: (3)

Yea man thanks alot. Has anyone here pulled the head studs out with just a 5 point hex socket? I've been looking for a ten point everywhere and cannot find one, the 5 point fits in there, I don't want to run the risk of stripping the bolt, but I'm running out of options here, I have ARP studs going in, just wondering if I can break the studs loose with a 5 point.... If it strips I'm F'd.