ECU/E-manage issue
#1
ECU/E-manage issue
I have my E-01 Boost controller connected to my e-manage and mistakenly confirmed something on the parameters and now the car is acting like crap (Idles super low, 4kmax rev, no boost)...
Does anyone know some way to possibly reset this to last tune? I'm guessing i have no choice but to get it re-tuned... Also, would it be safe to drive the car over 100miles out since there is no where close that even tunes 1jz's or anything Imported near by... The worse part about it is that the SC is my only car
Does anyone know some way to possibly reset this to last tune? I'm guessing i have no choice but to get it re-tuned... Also, would it be safe to drive the car over 100miles out since there is no where close that even tunes 1jz's or anything Imported near by... The worse part about it is that the SC is my only car
#2
Does anyone have a map i can use?
Currernt set up:
1jz
T67
680cc
264in/out cams
fuel regulator
walbaro fuel pump
No idea how to set the parameters on the e-manage, just want to know if any of you turbo guys have the parameters for the e-manage loaded somewhere so i can get my car up and going.
Currernt set up:
1jz
T67
680cc
264in/out cams
fuel regulator
walbaro fuel pump
No idea how to set the parameters on the e-manage, just want to know if any of you turbo guys have the parameters for the e-manage loaded somewhere so i can get my car up and going.
#3
the emanage is very tempermental to be honest and i dont recommend you use anyone else's tune as your own. alot of things come in to play when you car was tuned, elevation, boost and mods play a major factor. Just take it in to get retuned man, sorry.
Thread
Thread Starter
Forum
Replies
Last Post
StuntKing
Performance & Maintenance
13
12-13-12 10:03 PM
Lexatlast
GS - 1st Gen (1993-1997)
10
01-22-09 06:24 AM