Thank you for the inputs

 

Hi, looking to add a sub, which speaker did you tap into, the front or rear speakers as I don't have a factory subwoofer to tap into

 

So, I’m tempted to purchase a used NX probably around 2017. I have a bunch of stereo equipment from my vehicle I might be losing. Two Zapco amps, one is a 4 channel and the other is a sub amp, I have one set of the Pioneer TSZ series high end 6.5 mids and tweeters, as well as a pair of morel 4 inch mid range and 6.5 inch midrange speakers and 2 8 inch subs. I want to transplant as much as I can to the NX if that becomes the next vehicle I purchase. What would I need to integrate that to the factory NX audio system? I know there are some adapters/modules that you can by pass the factory amps. Is this something I can do easily? Or am I looking at the wrong solution?

 

yes there are some harnesses and adapter, but you always have to use a LOC and do it manualy. Take a good loc ,because you can get into trouble and issue with pop ,humm etc or get a good DSP(HELIX DSP )
About the speakers: the front in Morel speakert will be good ( i am not a fan of Morel speaker , but their 4" are one of the best 4" and will do the job if you want to go below 500hz .You can add 8inc sub without damaging the pannel too (these are not realy sub ,these are woofer wich tend to low frequency )
For rear i will use the pioneer .(i am a "Pioneer"man but sorry i do not like the TSZ ...

 

Thanks, my subs are in a custom
box now that I would try to use in the new ride, they hit pretty hard with nearly over 1000watts pushing them now. My pioneer, I love the new tweets, so crisp and clean, probably too sharp for some but I listen to a lot of Rock and Alternative Rock that suits them well, I’d shoot for them for the front, the 6.5 can handle 300rms which they are getting close to that now they way they are in my current ride. I’m close to 2000 watts total power right now actually. Since I’m looking at used a used NX, I won’t know what system it will have once I know for sure if they total out my current ride.

My brother in law has a dude that put together his 18 tundra system I’m hoping maybe he’d help me, if I can’t do this myself.

 

It’s been a while but I no longer own this NX but everything was done on it. Full Helix system, 3 way fully active competition series, 2 way component rear, helix dsp pro mk2, 2 helix A4 amp, 1 helix A2 and all audison wiring.

 

For those who changed your front corner dash speakers, did you have to modify the cover to fit? Or did you have speakers that just easily fit the circle that is part of the cover that fits over the speaker?

 

I replaced mine with Focal's and to be honest, didn't even pay attention to that and just smacked the cover back on, might need to pull mine up and see if it did any damage lol but it did clip in so the speaker itself was not obstructing the cover.

 

I replaced my 2015 nx200t with Morel 402 Hybrids, they needed minimal work to get them to drop in, I even angled them slightly to achieve a better angle.