Knock sensor change out gone bad!
Thread Starter
Driver School Candidate
Joined: Dec 2016
Posts: 3
Likes: 0
From: Wa
Knock sensor change out gone bad!
So I changed out my knock sensor's and Harness, and plugs on my 2000 Rx 300. Put it back together and now car shifts very erratic and feels like it goes out of gear.. I have reset ECM and I am at a loss for answers. Any help would be much appreciated.
CL Community Team
Joined: May 2005
Posts: 7,230
Likes: 1,746
From: VA
The new part may be defective. Did run better with the old part? I would swap the old one back in and see if it runs better or the same as before. Of course, make sure all wires are secured correctly and no plugs are broken. Also make sure you re-connected anything else you had to take apart to do this job. Sometimes (I have done this) you forget to re-connect that one item and the car runs worse or not at all.
Thread Starter
Driver School Candidate
Joined: Dec 2016
Posts: 3
Likes: 0
From: Wa
The new part may be defective. Did run better with the old part? I would swap the old one back in and see if it runs better or the same as before. Of course, make sure all wires are secured correctly and no plugs are broken. Also make sure you re-connected anything else you had to take apart to do this job. Sometimes (I have done this) you forget to re-connect that one item and the car runs worse or not at all.
Thread Starter
Driver School Candidate
Joined: Dec 2016
Posts: 3
Likes: 0
From: Wa
Knock sensor change out gone bad!
All is good, car is running great again! The ground on the back of the air intake is very important.... Secured ground and car runs and shifts perfect.
Thread
Thread Starter
Forum
Replies
Last Post
Billysiano
RX - 1st Gen (1999-2003)
8
Sep 12, 2018 12:16 PM
