does anyone have a DIY on this? Wheel bearings shouldn't be hard but the whole 12t hydralic press issue is worrying me...I don't trust myself with 12tons.

Also, would alignment be necessary after this?

 

i just replace my upper control arms and now i think my front right wheel bearing is bad now,for example, my steering wheel shacks and the feelings comes from the right portion of the steering wheel and the rim has and wobbling look to it when i'm going 20 mph.

 

On I'm about to start working on the front wheel bearing for my 93 LS400, Does anyone know if they required two seals or just one? Because I can't seem to find the outer seal for the front wheel bearing; only the inner one comes up when I google them.

 

You should have 2 seals an inner and outer