i was just wondering anybody debadge their lx 570? is there holes? i like the look of debadged...the embels that says lexus and lx570 in the rear...

 

If they are like all the past, they are just stuck on with adhesive, no holes. I watched when they removed all the gold stuff off my Black LX470 and put on all new chrome and all emblems use adhesive only, even in the grill.

 

I did it on my 2010 Tundra Crewmax Limited 4X4
It's easier if you leave it in the sun for a while (or use a hairdryer) I used dental floss pulling the badges up slowly left to right. You'll find some of the adhesive remains but that can be easily buffed out with a good quality wax & some elbow grease.

 

Welcom..just adhesive. I debaged my range rover with a hair dryer. Just try to let the heat make it fall off, rather than trying to pulll it off. It makes clean up easier. WD-40 helps get the adhesive off but need to clean and wax after. Dont wait too long to debadge unless you keep her in a garage.

 

thanks for all the input.... i went ahead took on the debadging today bought some 3m adhesive remover.. and watch this videohttp://www.youtube.com/watch?v=5saNP7cdFck
i will post pic. of after debadging later today.....thanks...

 

Could you post a pic I have been thinking of doing the same

Thanks

 

I think there are holes, because the new Lexus vehicles have holes.

My 2nd generation IS does have holes.

 

here pics of debadged... it took 15min to do the 3m adhesive works awesome..no holes..

also today had some time so i hook up the v1 to map lights.. i might end up getting blendmount so it will look better instead of suction things..

next mod will be getting my wheels powder coated to matte flat black..
tint the rear hatch
4300k hid low beam
yellow fog lights

 

You guys are lucky for not having holes!

 

THat looks good. I think I will do mine next weekend. Thanks for posting the pics.