When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
New owner of previously owned 2008 LS600hL and it has the recurring "PCS not available now" dinging message and i want to disable it for now. Upon researching it i found that it should be under the steering wheel presumably next to the TPMS reset button but I am not seeing it. The location I was expecting it to be (to the left of the TPMS reset) actually has two wires going into what looks like a blank plastic cover plate but no button. I will try to post a picture shortly.
My question is this: Is this the correct location for the PCS enable/disable switch or am I looking in the wrong area?
It could be off or not functioning properly but I can't find the button to verify. That thread is what lead me to look under the steering wheel but I don't see it anywhere. I can't find the "pre-crash" button shown in that thread
Here's a pic from under my steering wheel. This is where I was expecting the pre crash on/off button to be. As you can see in the pic there is a plastic "blank" to the left of the TPMS set button. There are two wires going into the back of this "blank". Is this supposed to be the location of the pre-crash on/off button or am i looking in the wrong place?
OK, thanks. That explains why I couldn't find it! I'm thinking that the ECU has an issue and needs a reset or replacement. I'm going to pull fuses to the ECU to see if a hard reset will clear the PCS error. If not, I'll bite the bullet and head to the dealer.
Just wanted to chime in for anyone who is looking for this answer. The button on the 2008 LS is much further under the steering wheel, almost above the gas pedal. Will try to put a pic here later.